ここから本文です
TWO:
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:Lawton produced a brace of revolvers."Been hamstrung," the officer bawled back hoarsely.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:"It might for me," he said, "but not for her, and I[Pg 15] told Cabot I'd do my best for her." It had seemed to him his plain duty, and he had done it, and he asked no approbation."Now," said Taylor, distinctly, "oblige me with another lemon pop, mister." A cheer went up, and the minister standing above his fallen enemy raised the[Pg 45] third glass. "Here's to your better judgment next time, my friend. 'Tain't the sombrero makes the shot," he said. His seamed, small face was pale underneath its leathery skin, but by not so much as a quiver of an eyelid did he give any further sign of pain.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:He watched her as she went out of the tent, and the surgeon and steward worked with the shining little instruments.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:But this the civilians were very plainly not minded to do. They dropped back, now to cinch up, now to take a drink from the flasks, now to argue, once for one of their number to recover from an attack of heart disease.But she sat up suddenly, with one of her quick movements of conscious strength and perfect control over every muscle, clasped her hands about her knees, and went on. "It was very curious," and there came on her face the watchful, alert, wild look, with the narrowing of the eyes. "It was very curious, I could not[Pg 84] have stayed indoors that night if it had cost me my life—and it very nearly did, too. I had to get out. So I took my revolver and my knife, and I went the back way, down to the river. While I was standing on the bank and thinking about going home, an Indian stole out on me. I had an awful struggle. First I shot. I aimed at his forehead, but the bullet struck his shoulder; and then I fought with the knife. As soon as I could slip out of his grasp, I went at him and drove him off. But I didn't know how badly he was hurt until the next day. The shot had roused them up here, and they went down to the river and found him bleeding on the sand.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.