撸师爷久久爱_"五月婷婷久久大香蕉 "_一本道久久爱综合无码_欧美一级巨乳久草在线看

THREE:"And why not?" Balmayne growled. "Stranger things have happened. I know a poor man at this minute who owns one of the richest gold mines in the world. He won't work it because when the gold was found he quarrelled with his partner on the spot and killed him. That's a fact." FORE:In shading drawings, be careful not to use too deep tints, and to put the shades in the right place. Many will contend, and not without good reasons, that working drawings require no shading; yet it will do no harm to learn how and where they can be shaded: it is better to omit the shading from choice than from necessity. Sections must, of course, be shaded��not with lines, although I fear to attack so old a custom, yet it is certainly a tedious and useless one: sections with light ink shading of different colours, to indicate the kind of material, are easier to make, and look much better. By the judicious arrangement of a drawing, a large share of it may be in sections, which in almost every case are the best views to work by. The proper colouring of sections gives a good appearance to a drawing, and conveys an idea of an organised machine, or, to use the shop term, "stands out from the paper." In shading sections, leave a margin of white between the tints and the lines on the upper and left-hand sides of the section: this breaks the connection or sameness, and the effect is striking; it separates the parts, [85] and adds greatly to the clearness and general appearance of a drawing.The third plan of boring with bars resting in bearings is more extensively practised, and has the largest range of adaptation. A feature of this plan of boring is that the form of the boring-bar, or any imperfection in its bearings, is communicated to the work; a want of straightness in the bar makes tapering holes. This, of course, applies to cases where a bar is fed through fixed bearings placed at one or both ends of a hole to be bored. If a boring-bar is bent, or out of truth between its bearings, the diameter of the hole being governed by the extreme sweep of the cutters is untrue to the same extent, because as the cutters move along and come nearer to the bearings, the bar runs with more truth, forming a tapering hole diminishing toward the rests or bearings. The same rule applies to some extent in chuck-boring, the form of the lathe spindle being communicated to holes bored; but lathe spindles are presumed to be quite perfect compared with boring bars.