ONE:Presuming an engineering establishment to consist of one-storey buildings, and the main operations to be conducted on the ground level, the only vertical lifting to be performed will be in the erecting room, where the parts of machines are assembled. This room should be reached in every part by over-head travelling cranes, that cannot only be used in turning, moving, and placing the work, but in loading it upon cars or waggons. One result of the employment of over-head travelling cranes, often overlooked, is a saving of floor-room; in ordinary fitting, from one-third more to twice the number of workmen will find room in an erecting shop if a travelling-crane is employed, the difference being that, in moving pieces they may pass over the top of other pieces instead of requiring long open passages on the floor. So marked is this saving of room effected by over-head cranes, that in England, where they are generally employed, handling is not only less expensive and quicker, but the area of erecting floors is usually one-half as much as in America, where travelling-cranes are not employed.
TWO:
ONE:With Neros visit to Greece in 66 the reaction begins. When, a few years later, the empire was disputed between a general from Gaul and a general from Syria, it was the candidate of the Eastern legions who prevailed; the revolt of Judaea drew attention to Eastern affairs; and the great campaigns of Trajan must have definitely turned the tide of public interest in that direction, notwithstanding the far-sighted protest of Tacitus. On more peaceful ground, Hadrians Asiatic tours and his protracted residence in Athens completed the work inaugurated by Nero. In his reign, the intellectual centre of gravity is definitely transferred to Greece; and Roman literature, after its last blaze of splendour under Trajan, becomes extinct, or survives only in forms borrowed from the sophistical rhetoric of the East.As a means for transmitting power, shafts afford the very important advantage that power can be easily taken off at any point throughout their length, by means of pulleys or gearing, also in forming a positive connection between the motive-power and machines, or between the different parts of machines. The capacity of shafts in resisting torsional strain is as [46] the cube of their diameter, and the amount of torsional deflection in shafts is as their length. The torsional capacity being based upon the diameter, often leads to the construction of what may be termed diminishing shafts, lines in which the diameter of the several sections are diminished as the distance from the driving power increases, and as the duty to be performed becomes less. This plan of arranging line shafting has been and is yet quite common, but certainly was never arrived at by careful observation. Almost every plan of construction has both advantages and disadvantages, and the best means of determining the excess of either, in any case, is to first arrive at all the conditions as near as possible, then form a "trial balance," putting the advantages on one side and the disadvantages on the other, and footing up the sums for comparison. Dealing with this matter of shafts of uniform diameter and shafts of varying diameter in this way, there may be found in favour of the latter plan a little saving of material and a slight reduction of friction as advantages. The saving of material relates only to first cost, because the expense of fitting is greater in constructing shafts when the diameters of the different pieces vary; the friction, considering that the same velocity throughout must be assumed, is scarcely worth estimating.
TWO:(1.) Describe the different modifications of screw-cutting machines.(2.) What is gained by revolving the dies instead of the rod?(3.) What is gained by expanding dies?(4.) What is the difference between screws cut by chasing and those cut on a screw-cutting machine?
