In those days German Headquarters gave continuously the thoughtless order: "To Calais, to237 Calais," and the Staff considered no difficulties, calculated no sacrifices, in order to achieve success.A great share of the handling about an engineering establishment is avoided, if material can be stored and received on a higher level than the working floors; if, for instance, coal, iron, and sand is received from railway cars at an elevation sufficient to allow it to be deposited where it is stored by gravity, it is equivalent to saving the power and expense required to raise the material to such a height, or move it and pile it up, which amounts to the same thing in the end. It is not proposed to follow the details [74] of shop arrangement, farther than to furnish a clue to some of the general principles that should be regarded in devising plans of arrangement. Such principles are much more to be relied upon than even experience in suggesting the arrangement of shops, because all experience must be gained in connection with special local conditions, which often warp and prejudice the judgment, and lead to error in forming plans under circumstances different from those where the experience was gained.
Director
For other kinds of work there are drawings furnished, and the plans are dictated by the engineering department of machinery-building establishments, but pattern-makers make their own plans for constructing their work, and have even to reproduce the drawings of the fitting-shop to work from. Nearly everything pertaining to patterns is left to be decided by the pattern-maker, who, from the same drawings, and through the exercise of his judgment alone, may make patterns that are durable and expensive, or temporary and cheap, as the probable extent of their use may determine.But fruitless births the sterile earth did bear."Charlton's white set face as he pressed against the panes."--Page 124In spiral gearing the line of force is at an angle of forty-five degrees with the bearing faces of the teeth, and the sliding movement equal to the speed of the wheels at their periphery; the bearing on the teeth, as before said, is one of line contact only. Such wheels cannot be employed except in cases where an inconsiderable force is to be transmitted. Spiral wheels are employed to connect shafts that cross each other at right angles but in different planes, and when the wheels can be of the same size.60