ここから本文です
TWO:"I'm not going away till I've got them," he said doggedly.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:I took the liberty to explain to the officer that the man did not understand him, and stated that he did not know me."Then I began to understand. You were only a little time from the room. Why did you go from the room? Ostensibly to see Captain Gifford off in his new autocar. Here was a possible solution. I saw Gifford later, and he told me that you had been larking off in his car for twenty minutes--long enough at that time of night to get to my chambers and back easily.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:I could not help myself, but also pressed through the Germans, as I wanted to exchange a few words with the Belgians. This was possible for a very few moments only, in which they told me that they had been firing night and day in order to harass the Germans who crossed the river, but they had to yield at the end, when the Germans put Belgian civilians in front of themselves when attacking the fort.Platens as a rule run back at twice the forward or cutting movement, and as the motion is uniform throughout each stroke, it requires to be stopped at the extremes by meeting some elastic or yielding resistance which, to use a steam phrase, "cushions" or absorbs the momentum, and starts the platen back for the return stroke.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:The trembling fit passed away, the woman was herself again. All the same, Balmayne was not without misgiving as he put his foot in the loop. But the crank of the windlass turned steadily and smoothly, the stone walls slid by, and presently the adventurer stood at the bottom of the well. There was no water, nothing but a slight dampness underfoot.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.