ONE:Dimension lines should be in blue, but may be in red. Where to put them is a great point in draughting. To know where dimensions are required involves a knowledge of fitting and pattern-making, and cannot well be explained; it must be learned in practice. The lines should be fine and clear, leaving a space in their centre for figures when there is room. The distribution of centre lines and dimensions over a drawing must be carefully studied, for the double purpose of giving it a good appearance and to avoid confusion. Figures should be made like printed numerals; they are much better understood by the workman, look more artistic, and when once learned require but little if any more time than written figures. If the scale employed is feet and inches, dimensions to three feet should be in inches, and above this in feet and inches; this corresponds to shop custom, and is more comprehensive to the workman, however wrong it may be according to other standards.
FORE:No, Dick agreed, seeing no fun in the situation for once. See! There is a motor connected to a big drum up in the top of the hangar, and the door is counterbalanced so that turning the drum winds up the cable that pulls it up. I suppose the motor reverses to run it down andI had a short chat with the wounded men near the various houses, on demand showed my passport to those in authority, and was advised as a friendly Netherlander to return, as it was extremely dangerous on the road. But I did not dream of doing34 this, as long as I was not compelled, and went on towards Lige amidst this maddening thunder.
FORE:"I have to my hand," Lawrence went on, "the materials for a magnificent romance. Let us go back a little while. Some week or two ago here we discussed the Corner House. I said it would make the scene of a capital romance. I went further and said I had already sketched the story out. You recollect that?"