美女黄片A片_美女黄色一级片电影_美女黄色图片_美女黄频美拍一级视频免费

THREE:Tools should never be tempered by immersing their edges or cutting parts in the bath, and then allowing the heat to "run down" to attain a proper temper at the edge. I am well aware that this is attacking a general custom, but it is none the less wrong for that reason. Tools so hardened have a gradually diminishing temper from their point or edge, so that no part is properly tempered, and they require continual re-hardening, which spoils the steel; besides, the extreme edge, the only part which is tempered to a proper shade, is usually spoiled by heating and must be ground away to begin with. No latheman who has once had a set of tools tempered throughout by slow drawing, either in an oven, or on a hot plate, will ever consent to point hardening afterwards. A plate of iron, two to two and one-half inches thick, placed over the top of a tool dressing fire, makes a convenient arrangement for tempering tools, besides adding greatly to the convenience of slow heating, which is almost as important as slow drawing. The writer has by actual experiment determined that the amount of tool dressing [117] and tempering, to say nothing of time wasted in grinding tools, may in ordinary machine fitting be reduced one-third by "oven tempering."

Sed ut perspiciatis unde omnis iste natus error sit voluptatem accusantium doloremque laudantium. repudiandae sint et molestiae non recusandae. Itaque earum rerum hic tenetur a sapiente delectus, ut aut reiciendis voluptatibus maiores alias